1000 kVA Servo Voltage Stabilizer

1,391 A per phase

At 415 V three-phase, 1000 kVA works out at roughly 1,391 A per phase. 1,391 A is a substation-scale connection. Cable is no longer sensible: this terminates on busduct, and the connection design — bar sizing, joint torque, thermal expansion allowance over the run — becomes a piece of engineering in its own right rather than a cable schedule. We supply the termination arrangement with the unit so the interface is settled before either side is built.

300V–470V

The unit holds output at 415V ±1% anywhere between 300 V and 470 V in. Pulling a 300 V supply back up to 415 V means adding 115 V — a 38% lift on the incoming supply, with the series winding carrying roughly 277 kVA of the 1000 kVA throughput. Below 300 V it runs out of range, and the answer is a wider-window build, not more kVA.

< 20 ms

At this scale the stabilizer is effectively part of the incoming supply rather than a device hanging off it, and < 20 ms is what stops a disturbance anywhere in the plant from becoming a disturbance everywhere. Sites at this rating usually want the correction logged as well as performed — the remote monitoring option exists for exactly that.

150% for 30 minutes

Direct-on-line starting draws six to eight times full-load current for a few seconds, and 150% for 30 minutes is the margin that absorbs it. At 1000 kVA the practical constraint is usually the largest single motor rather than the total: size against that starting current, not against the sum of the nameplates.